Bleach Online Forum

Title: unrelated to Bleach online... [Print this page]

author: MylarHyrule    time: 2017-3-23 08:30:56     Title: unrelated to Bleach online...

I've been looking into getting a 3d printer...

seen those $50 to $100 ones you have to build yourself...

given i can build it correctly and set it right, do they print well?

I'm only looking to print smaller things, mainly for fidget spinners and such

any input would be appreciated greatly!!

Thanks in advance!!
author: Raeace    time: 2017-3-23 08:37:18

I think google is better friend than bleach online forums could be when it comes to 3d printing.
author: chiko88soem    time: 2017-3-23 08:39:30

nooo dont spend money on a 3d printer

spend the money on bleach online

make gogames proud
author: trojandrew    time: 2017-3-23 09:00:06

They work decent. You can make things from 3ds cases to small legs parts. The only thing I found with them is get a sanding kit since it'll have little edges and nicks you'll want to sand down to get the edge off. I suggest fine sanding pencils from a craft store
author: MylarHyrule    time: 2017-3-23 09:57:50

Raeace replied at 2017-3-23 08:37
I think google is better friend than bleach online forums could be when it comes to 3d printing.

I've looked elsewhere for input there...  some people here tho i trust their input on technical stuff like that...  I'd rather ask 40 people too many than to make one bad move, lol
author: MylarHyrule    time: 2017-3-23 09:58:36

trojandrew replied at 2017-3-23 09:00
They work decent. You can make things from 3ds cases to small legs parts. The only thing I found wit ...

thanks for that input...   also, with a fidget spinner...  a tri spinner to be exact, my research tells me that probably 20% infill would be plenty, any experience with this?
author: trojandrew    time: 2017-3-23 10:00:10

MylarHyrule replied at 2017-3-23 09:58
thanks for that input...   also, with a fidget spinner...  a tri spinner to be exact, my research  ...

No hands on experience with that part sry
author: MylarHyrule    time: 2017-3-23 12:45:49

trojandrew replied at 2017-3-23 10:00
No hands on experience with that part sry

thanks anyway!!
author: LadyKyojin    time: 2017-3-25 14:16:21

they not to bad my freinds has one it do simple small stuff nothing uber if you looking into 3d printing its a good place to start it not to expensive and you will have a general idea once you start to print stuff off we tried cloning WH40k figurines not bad turn out lol




Welcome to Bleach Online Forum (http://forums.gogames.me/) Powered by Discuz! X2